Process flow layout 1. Bottom processing, processing volume; 2. The benchmark of the casting blank is corrected, and the 2D and 3D surface balances are introspected; 3, 2D, 3D surface roughing, non-device non-task plane processing (including safe platform surface, buffer device surface, platen plane... read more
Mold design refers to the digital design of the enterprise mold. A mold is an industrial product that shapes a material in a certain manner in a specific structure. So what are the mold design steps? First, to carry out product feasibility analysis, to independently analyze the product drawings, it ... read more
The molten plastic in the cavity meets in the form of multiple strands due to the intrusion of the insert holes, the inconsistent flow rate, and the region where the filling flow is interrupted, and a linear weld seam is produced because it cannot be completely fused. In addition, in the case of gat... read more
Diamond grinding and polishing should pay attention to the following points (1) This polishing must be carried out under light pressure as much as possible, especially when polishing pre-hardened steel parts and polishing with fine abrasive paste. When polishing with #8000 abrasive paste, the common... read more
Some injection mold workers who have been engaged in many years will find that sometimes the processed mold will shrink and sag. What is the matter? What are the causes of these situations? 1. Machine side: 1. The nozzle hole is too large to cause the melt to recirculate and shrink. When the pressur... read more
