Seal The Hengxin PET Mould To Isolate Mildew

08 Mar 2018

There is no doubt that quick response and effective containment can help significantly reduce the size and cost of mold losses. Isolation is the content of containment. You sealed the moldy infected room with a plastic film so the PET mould could not escape and contaminate the rest of your home. Another approach is to use a source seal that focuses on the surface that encapsulates or seals the PET Mould to its growth. This makes sense because it first prevents the mold from becoming air.

There are three ways to seal: polymeric film, tape, "stick back" carpet protective tape and tape, and newer "wet" technology tape. The multi-film method essentially "packs" the mold onto its major surface. Mold can be released, but remain "bagged." This method requires two people to apply for and use readily available materials, but may be susceptible to damage during the repair process.

The carpet protection method uses "sticky pads" designed to protect your floor from construction activities. These pads use acrylic adhesives and require a dry, clean surface to be effective. Mainly because there is no "wet" technology available. They tend to fall off moldy surfaces and must be glued to adjacent surfaces to work. The application usually requires two people. They can easily compromise and release mold during recovery.

Newer "wet" technology methods use specially designed tapes or cracked n-peel bandages and engineering adhesives that adhere to wet surfaces. They are applied directly to the mold. This method is easy to apply, requires only one person, and causes minimal interference. During use, any interference with the mold will be glued to the adhesive with the barrier. It is trapped on fly paper to prevent further contamination. This method is very effective, very difficult to compromise, and has become part of some companies' standard mold agreements.

Please enter the word you want to search